Headlamp Switch Test - Polaris Sportsman 700 Efi 2005 Service Manual

Table of Contents

Advertisement

ELECTRICAL
Lower Headlamp Housing Removal
(if required)
5. Remove the screw that secures the lower
headlamp.
Remove Screw
6. Pull the headlamp out of the locking tab.
LOW BEAM HEADLIGHT
ADJUSTMENT
1. The low beam can be adjusted slightly upward or
downward.
Loosen Screw
2. Loosen the phillips screw located at the rear of the
headlamp.
3. Tilt the headlamp upward or downward.
4. Tighten the screw.
10.32

HEADLAMP SWITCH TEST

1. Remove the headlight pod cover.
2. Set meter to DC Volts and probe the headlamp
plug wires (Brown and Yellow) at back of
connector for 12 Volts.
3. Turn ignition and headlight on. If there is no
power, continue with checks to the harness and
fuses.
Brown
Yellow
Upper Headlamp Plug Wires
Brown
Green
WORKLIGHT SWITCH
Remove the headlight pod cover to locate the switch
wires. The switch snaps out by pushing in on the tabs
on both sides of the switch.
Squeeze Tabs -- Push Thru to Remove
If the rear work lights will not come on, check the
following:

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sportsman 800 efi 2005

Table of Contents