Polaris Sportsman 700 Efi 2005 Service Manual page 107

PU- -45498
27. Reinstall the camshaft gear; so the timing marks
are properly aligned. Install the washer and bolt.
Torque to 22 ± 2 ft. lbs.(30 ± 3 Nm).
NOTE: Be sure all of the timing marks are properly
aligned.
K
Timing Marks
M
Water Pump Gear
N
Timing Marks
Counterbalance Gear and Camshaft
Gear Bolt Torque:
22 ± 2 ft. lbs. (30 ± 3 Nm)
GEAR/STATOR HOUSING SEAL REPLACEMENT
IMPORTANT: Due to
construction, these seals MUST be installed dry
(no lubricant) during assembly. Use of lubricants
(oil, soapy water, etc.) will not allow the seal to
wear- -in and seal properly. Do not touch seal
surface or allow seal surface to come in contact
with contaminates
Thoroughly clean parts, tools and hands before
installation.
28. Before installing the gear/stator housing, replace
the seals in the cover. Install a new water pump
seal (N) into the gear/stator housing (O). Use the
Water Pump Mechanical
(PA- -44995) to properly install the seal to the
correct depth in the cover.
ENGINE
Timing Marks
seal design and
during installation.
Seal Installer
3.53