Check for continuity between the switch
G
contacts -- Place meter leads between two
contacts with switch in ON position.
Probe the worklight plug wires at back of
G
vehicle, there should be at least 12V at the
plug.
Check for 12 volt power at the blue wire.
G
Worklight Plug Wires
BRAKE LIGHT / WORK LIGHT
REPLACEMENT
The brake light (A) and the work light (B) are both
located in the rear tail lamp housing.
B
1. To remove the worklight electrical connector (B),
pull down on the connector lock and pull the
connector from the bulb assembly.
B
A
2. To remove the brake light electrical connector (B),
press in on the tab on the connector to unlock the
connector and pull the connector from the bulb
assembly.
A
3. To remove either of the bulbs, turn the holder
assembly counter--clockwise to remove and pull
out.
Turn the holder assembly clockwise to
install. Refer to the parts manual for the correct
bulb part number.
Install
ELECTRICAL
Remove
10.33