Maintenance; General; General Cleaning; Cleaning The Brushes - Neopost INSERTER IN-3 SI-92 Operator's Manual

9.

MAINTENANCE

9.1

General

The IN-3 requires just a few maintenance activities for the
operating personnel. These are:

• general cleaning.

• cleaning the brushes.

• cleaning the moistening cloth.

• cleaning the sealing roller.

Disconnect the mains supply before performing
any maintenance.
The user must not attempt to service the appliance
beyond that described in this operator manual. All
other servicing must be carried out by qualified
service personnel only. Please contact your
authorized distributor.
SI-92
Fig. 35
9.2 General cleaning
The machine must be kept in proper condition by regularly
removing dust, paper remains, etc. Clean the sealing table
and rubber rollers when dirty. This can be done by using a
slightly wetted cloth.
9.3 Cleaning the brushes
Clean the brushes when dirty or saturated with glue. An
extra set of brushes is provided. The best procedure is to
always soak one set of brushes and use the other set. In that
way there is always a clean set of brushes ready for usage.
To replace the brushes the transparent cover and loc must be
lifted. The loc can be released by pulling the release handle
of the loc (see Fig. 32). The brushes can be removed one by
one by pulling them straight off the brush holder (see Fig.
35). When replacing the brushes, align the studs on each
brush with the respective holes in the holder.
Fig. 36
9.4 Cleaning the sealing roller
The sealing roller A (Fig. 36) must be cleaned regularly with
a slightly wetted cloth.
9.5 Cleaning the moistening cloth
Clean the moistening cloth A (Fig. 37) and water tray when
dirty or saturated with glue. To remove the watertray the
transparent cover, loc (by pulling the release handle) and
sealing table (by pulling the locking handle) must be lifted.
Remove the bottle C and then remove the watertray B by
pulling it towards the hopper. Clean the water tray under
running water.
Fig. 37
31/40