Neopost INSERTER IN-3 SI-92 Operator's Manual page 12

Feed one envelope
With this function the proper feed of envelopes can be
tested. First carry out the envelope hopper adjustments, see
section 5.7 on page 17. Then put a stack of envelopes in the
hopper. Use key 1 or key 2 to feed one envelope onto the
insert table. Each time the key is pressed a new envelope
will be fed. No insertion will take place.
The "feed one envelope" function can be used when
adjusting the envelope stop position, see "Envelope stop
position adjustment" on the next page.
12/40
Key
1
2
3
4
5
6
Fig. 18
Insert one document
With this function the proper functioning of the whole
document and envelope transport will be tested. First carry
out all adjustments, see section 5.7 on page 17. Then load
the system with documents and envelopes.
Use key 3 to make one insert cycle. Each time the key is
pressed another insert cycle will be made. When there is no
envelope waiting on the insert table, the machine feeds one
envelope waiting on the insert table. The document will be
inserted and filled envelope is ejected.
If there are documents on the collating area, these
documents will be inserted and the filled envelope is ejected
(and counted). If there is an empty envelope in the inserter,
this envelope will be ejected.
See notes mentioned in section 6.2 on page 22.
(5x)
Envelope stop position adjustment
The flap folding line must be positioned under the green
indicator B (Fig. 19). This indicator can be seen after
opening the transparent cover and releasing and lifting the
loc by pulling the release handle of the loc (see page 5).
If necessary, adjust the folding line position by pressing "to
the right" (key 4) or the "to the left" (key 5). Each press
stops the next envelope 1 mm (0,04 inch) to the right (later)
or left (earlier).
Adjustments to the envelope stop position can be made with
the system operating.
Fig. 19
SI-92