Counters Menu; Settings Menu - Neopost INSERTER IN-3 SI-92 Operator's Manual

5.4.5

Counters menu

After pressing key 4 in the "main menu", the display shows
the "change counters" menu (Fig. 21). The "change
counters" menu shows the following functions:
• increase the counters (key 1).
• decrease the counters (key 2).
• reset counters to zero (key 3).
• increase the preset counters (key 4).
• decrease the preset counters (key 5).
• save the counter settings with "OK" (key 6) which will get
you back to the "main menu".
Increase/decrease counters
The following counters will be increased or decreased:
• job counter.
• counter.
Reset counters to zero
The following counters will be set to zero:
• job counter.
• counter.
14/40
Key
1
2
3
4
5
6
Fig. 21
Increase and decrease preset counter
By pressing key 4 or key 5 the preset counter will be
increased or decreased.
The counter will only be displayed when the preset counter
is set higher than zero.
When pressing key 4 or key 5, the stop counter will initially
be increased or decreased with one unit at a time. When
the key is pressed longer the counter will be raised with ten
units at a time.
5.4.6

Settings menu

After pressing key 5 in the "main menu", the screen as
shown in Fig. 22 will be displayed. The "settings" menu
shows the following functions:
• job data (key 1).
• decrease contrast of the display (key 2).
• increase contrast of the display (key 3).
• thickness detection on or off (key 4).
• reset thickness detection (key 5).
• save the counter settings with "OK" (key 6) which will get
you back to the "main menu".
In case the system contains a VersaFeeder, via the settings
menu its double document detector can be switched on/off
and can be reset as well.
Display contrast
By pressing key 2 the display contrast will be decreased. By
pressing key 3 the display contrast will be increased.
Key
1
2
3
4
5
6
Fig. 22
SI-92