Si 92 Options - Neopost INSERTER IN-3 SI-92 Operator's Manual

Automatic selective feeding
With this option active, the other feed units (stations 1 and
2) on the transport unit will feed an enclosure depending on
the number of pages collated by the AS-1A. If the number of
pages in a set, collated by the AS-1A is less than the
number shown by the overflow display, station 1 and
possibly station 2 are allowed to feed a document. The total
number of pages, including enclosures, will not exceed the
number shown by the overflow display.
SI-92
Flexible reading
The AS-1A is capable of reading OMR codes other than the
standard built in Neopost code. Besides that, more than one
reading code can be programmed. If this is the case, a
submenu can be entered to select the appropriate code. To
do so, press both key A and the key B at the same time, see
Fig. 41 and Fig. 42. The display C (Fig. 43) will indicate a
number. Using the + and - key below display C the number
corresponding to the appropriate code can be selected.
Then again press both key A and the key B at the same time,
to leave the submenu.
Matching of two personalized documents
See section10.2, Feed unit FE-8.
Fig. 42
10.3 SI-92 options
Mix 'N Go ®
The Mix 'N Go feature enables automatic processing, in 1
®
run, of a batch of documents which requires inserting into
different sizes of envelopes. For a specific document set an
envelope from either hopper A or hopper B from the IN-3 is
selected. Together with envelope hopper selection, if
required, via the TR-7A "twin cycle" option, documents from
station 2 (3 and 4) are automatically folded/not folded
depending on the type of envelope.
Mix 'N Go can be based on:
®
• OMR mark (hopper selection mark).
• Type of enclosure to be added (selective feed mark).
• Number of pages in a set (AS-1A only, IN-3 dongle level
3 only).
• Combination of selection criteria.
Fig. 43
35/40