Figure 7.4: Multiple Vlan Configuration - HP bh5700 User Manual

•
Each VLAN interface is labeled zh p N in the file, where N is a value from 0-3. Each interface is
untagged and assigned its own IP address (see Figure 7.4).
The S50multivlan script executes the following commands:
•
/usr/sbin/zconfig zhp0: vlan1=zre0..5
/usr/sbin/zconfig zre0..5=untag1
/usr/sbin/zconfig zhp1: vlan2=zre6..11
/usr/sbin/zconfig zre6..11=untag2
/usr/sbin/zconfig zhp2: vlan3=zre12..17
/usr/sbin/zconfig zre12..17=untag3
/usr/sbin/zconfig zhp3: vlan4=zre18..23
/usr/sbin/zconfig zre18..23=untag4
NOTE: Double periods (..) after vlan1 and untag1 are used to indicate a range of values.
•
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
VLAN 4, zhp3: for last set of six ports, zre18-zre23
zhp0
VLAN1
zre1 zre3 zre5
zre0 zre2 zre4
Each VLAN (zhp) contains 6 ports (zre's)

Figure 7.4: Multiple VLAN Configuration

Runs zconfig to create and start four VLANs. Switch ports 0-9 are placed in the first
VLAN, ports 10-19 in the second VLAN, ports 20-21 are placed in the third VLAN, and
ports 22-23 are placed in the fourth VLAN.
Runs the Linux ifconfig command for each interface to assign default IP addresses
manuals search engine
Linux IP
zhp1 zhp2
VLAN3
zre13 zre15 zre17
zre12 zre14 zre16
VLAN2
zre7 zre9 zre11
zre6 zre8 zre10
release 3.2.2j
zhp3
VLAN4
zre19 zre21 zre23
zre18 zre20 zre22
page 101