Zbootcfg - HP bh5700 User Manual

zbootcfg

NAME
zbootcfg − Modifies the boot parameters of the OpenArchitect switch.
SYNOPSIS
zbootcfg -a | -d <device number> [<boot_string>]
DESCRIPTION
zbootcfg is used to display or modify the boot parameters on the switch. The boot parameters
are utilized by the minof boot loader application to indicate on which device to find a boot image.
Care should be taken when changing the boot string. Incorrect procedures can result in a switch
that cannot boot.
-d <device_number>
Three ROM boot devices are available in the switch. The
factory-shipped boot device is 1. The following describes each
boot device:
-d 1 Boot image located at offset 0 in the application flash
1. This is the factory-shipped location of the primary
OpenArchitect image.
-d 2 Loads an image located at offset 0 in the application
flash 2. This is the factory-shipped location for the
alternate OpenArchitect image.
Any characters after the -d <dev> parameters are saved in flash memory and passed unchanged
to the booting kernel.
OPTIONS
-a
shipping string is "dev1."
-d <dev>
<dev> value must be the number 1 or 2 corresponding to
application flash 1 or application flash 2, respectively.
<boot string>
is passed to the booting kernel. All characters
<dev> are passed unchanged to the booting kernel.
EXAMPLES
The following example illustrates a command for making the image boot from the second
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
Displays the current boot string. The default factory
Specifies the ROM device from which to boot. The
Optionally, a boot string may be provided that
manuals search engine
release 3.2.2j
after the -d
page 197