HP bh5700 User Manual page 270

other words there is a unique vrid to ifname associated with the
–i option.
-s
means that a Master switch will go to Backup if a current Backup
has higher priority.
-M
set on one host or the switches will oscillate. Must set –B
option on other hosts (requires preemption mode ! -s)
-B
-S <script>
-a <auth> (not yet implemented) set the authentication type
auth=(none|pass/hexkey|ah/hexkey) hexkey=0x[0-9a-fA-F]+
-p <prio> Set the priority of this host in the virtual server
(default is 100)
-f <piddir>
stored (default is /var/run)
-c <conf> Configuration read from conf file (required when
managing multiple Virtual Routers).
file are lines of command line options.
Virtual Router.
all Virtual Routers defined by the conf file.
the command line reads:
vrrpd –d 50 –c vrrpd.conf
And the vrrpd.conf file contains:
-v 1 –i zhp0 –I zhp3 10.0.0.42
-v 2 –i zhp1 –I zhp3 11.0.0.42
vrrpd would be started controlling two Virtual Routers; one for
10.0.0.42 and the other for 11.0.0.42.
50 option.
-d <delay> Set the advertisement interval.
By default time is specified in seconds.
in a lower case 'm' the time is specified in milliseconds.
millisecond specification results in a proprietary use of the
VRRP Adver Int field.
-m <address>
00:00:5E:00:01:<vid> to the provided addr.
input as 6 two digit hex numbers that are colon delimited with no
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
Toggle preemption mode (Enabled by default).
Become MASTER when priority is equal.
Become BACKUP when priority is equal.
script to be called when state change occurs.
specify the directory where the pid file is
Parameters given on the command line apply to
Change the virtual MAC address from
manuals search engine
Be sure it is only
See -M option
The contents of the conf
Each line represents a
So for example, if
They would both get a –d
Default is 1 second.
If the delay value ends
The addr should be
release 3.2.2j
Preemption
The
page 270