HP bh5700 User Manual page 264

bridge will not send or receive BPDUs, and will thus not
participate in the Spanning Tree Protocol. If your bridge
isn't the only bridge on the LAN, or if there are loops in the
LAN's topology, DO NOT turn this option off.
option off may impair
setbridgeprio
sets the bridge's priority to <priority>. The priority value
is an unsigned 16-bit quantity (a number between 0 and 65535),
and has no dimension. Lower priority values are better. The
bridge with the lowest priority will be elected Root Bridge.
setfd
sets the bridge's bridge forward delay to <time> seconds.
sethello <bridge> <time>
sets the bridge's bridge hello time to <time> seconds.
setmaxage
sets the bridge's maximum message age to <time> seconds.
setpathcost
sets the port cost of the port (zre#) to <cost>. This is a
dimensionless metric. The path cost is set to 100 for all
OpenArchitect switch ports by default. For the OpenArchitect
switch a port is zre1, zre2, ...
following:
setportprio
sets the port's priority to <priority>. The priority value
number between 0 and 255), and has no dimension. This metric
is used in the designated port and root port selection
algorithms. For the OpenArchitect switch a port is zre1, zre2,
...
NOTES
brctl(8) replaces the older brcfg tool.
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
<bridge>
<bridge> <time>
<bridge> <time>
<bridge>
Link
Speed
10 Mb/s
100 Mb/s
1 Gb/s
<bridge>
manuals search engine
network traffic, so be careful.
<priority>
<zre#> <cost>
IEEE 802.d recommends the
Recommended Recommended
Value Range
100 50-600
19 10-60
4 3-10
<zre#> <priority>
release 3.2.2j
Turning this
(a
page 264