HP bh5700 User Manual page 33

#vrrp_mode: block_crossconnect;
The next sections determines the failover mode between the Surviving Partner switches. There
are three modes:
failover_mode: switch;
Next, you can set VRRP_msg_rate and default priority. VRRP_msg_rate is the time in
milliseconds between vrrp message transmissions over the interconnect link. The
vrrp_def_priority is the default priority for both switches. The value is set to 254 and
should not require change.
vrrp_msg_rate: 100;
vrrp_def_priority: 254;
The following optional entries provide a mechanism to propagate files and/or startup scripts to
sibling switches. An example might be startup scripts or scripts to configure gated. Example
scripts are included to start gated with RIP1, RIP2, or OSPF setup. You must use absolute path
names.
# start_script:
are moved
# to the slave switches when they do a zspconfig -u.
example might
# be the gated configuration script S55...
names are
# required.
more than
# one file.
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
switch - Failover by switch. Failover from Master switch to Backup on any port
•
failure. The switch with the most links becomes the new Master. One port failure
will cause the switch to failover.
vlan - Failover by VLAN. The switch with the most up links in the VLAN becomes
•
the Master of that VLAN. When VLANs failover and all VLAN masters are not
located on a common switch, the interconnect link is used to carry data traffic, and
could become saturated. The use of the interconnect for data traffic in a failover
situation depends on the VLAN design, from one extreme where one VLAN could
contain all ports to one port per VLAN at the other extreme.
port - Failover by port. The Master switch will remain the Master until all ports in the
•
VLAN are down. The Backup then becomes the new Master for that VLAN.
Similar to VLAN failover, the interconnect link will carry data traffic in this mode,
when ports failover.
# In milliseconds
Allows the user to add files and scripts that
Multiple start_script commands can be used to move
manuals search engine
Absolute path
release 3.2.2j
An
page 33