Base Interface Out-Of-Band Ethernet Connection; Figure 10.2: Base Interface Serial Port - HP bh5700 User Manual

To attach the console cable to the Ethernet Switch Blade switch:
1. Plug the RJ-45 end of the console cable (P/N 6900-63006, shipped with the HP bh5700
2. Connect the DB-9 end of console cable into a standard Modem Eliminator Cable
3. Connect the DB-9 header on the other end of the Modem Eliminator Cable to a standard
4. Reinsert the switch into the system and power up.
5. Use a terminal emulation program to access the switch console.

Base Interface Out-of-Band Ethernet Connection

Connect an Ethernet cable from the Ethernet Switch Blade front panel MGMT OOB (2 in Figure
10.2) to your PC.
1. Configure a host on the 10.0.0.0 network.
2. The OpenArchitect switch is pre-configured with address 10.0.0.42. telnet to
3. After you are connected, enter the login name root. No password is required.
4. You are now logged in and should see the following shell prompt:
Ethernet Switch Blade User's Guide
Downloaded from www.Manualslib.com
Figure 10.2: Base Interface
ATCA 14-Slot Blade Server) into the RJ-45 Console Port (1) on the front panel.
(normally locally available).
COM port on your PC or laptop computer (9600, n, 8, 1).
10.0.0.42.
telnet 10.0.0.42
OpenArchitect login: root
[ZX6000-OA3.2.2h]#
manuals search engine
Serial Port
release 3.2.2j page 147