Kyocera TASKalfa 5500i Operation Manual page 406

LAN Interface
Specify the settings for the LAN interface to be used. The default setting is Auto.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-106.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [
3
Select [Auto], [10BASE-T Half], [10BASE-T Full], [100BASE-TX Half], [100BASE-TX Full] or [1000BASE-
T] as the LAN interface.
4
Press [OK].
Restart Network
To restart the network card of the device, follow the steps below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [
] and then [Change] of LAN Interface.
] and then [Start] of Restart Network.
9-106
Default Setting (System Menu)