Modifying Dhcp Settings; Enabling Dhcp; Disabling Dhcp - Altigen Alti-IP 600 Administration Manual

GateKeeper
Network>GK
Discovery
Discovery
Enable NAT
Network>Enable/
Disable NAT
NAT Address
Network>NAT
Address

Modifying DHCP Settings

Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when they are connected to the network.

Enabling DHCP

The Alti-IP 600 automatically enables DHCP by default, but you can reset
the protocol if it becomes disabled using the following steps:
1. Press * * 7 + ENTER button.
Use !/" to select Network, then press the Enter key.
2.
3. Scroll to Enable DHCP.
If DHCP is disabled, the option displays as DHCP Enabled NO.
Press " (DOWN key) to enable DHCP.
4.

Disabling DHCP

If you do not use DHCP in your network, you can disable DHCP before
manually assigning an IP address to the Alti-IP 600. To disable DHCP, use
the following steps:.
Note: Procedures involving configuring IP settings cannot be completed
when DHCP is enabled in your network.
1. Press * * 7 + ENTER button.
Use !/" to select Network, then press the Enter key.
2.
3. Scroll to Enable DHCP.
If DHCP is enabled, the option displays as DHCP Enabled YES.
Set to YES or NO to indicate whether
GateKeeper discovery is enabled. IP
Phone will automatically find
GateKeeper.
Set whether NAT is enabled or
disabled.
Sets the NAT server's public IP
address.
Alti-IP 600 Administration Manual 23