Configuring "Phone Setting" Soft Keys; Dialing An Ip Number Directly From The Alti-Ip 600; Operation Notes - Altigen Alti-IP 600 Administration Manual

Configuring "Phone Setting" Soft Keys

When the soft key is set to "Phone Setting" (in the IP Phone Configuration
window of AltiAdmin), the IP Phone user can configure the soft key to
store a speed dial number or feature code.
To configure a soft key with phone setting enabled:
1. Press * * 6, then the ENTER button.
2. Scroll to the program key to configure.
3. Enter the appropriate digits for the speed dial number or feature code.
The digits will be automatically dialed when this function key is pressed.
Dialing an IP Number Directly from the Alti-IP
600
To dial an IP number directly from the Alti-IP 600 phone set, enter the IP
address using the * key to enter periods followed by the # key.
Notes:
• This only works when the Alti-IP 600 is operating in basic mode.
• If the Alti-IP 600 is configured for a public IP address, you can call
other public IP address devices.
If the Alti-IP 600 is configured for a private IP address, you can call other
private IP address devices that you can "see" or that are on your subnet.

Operation Notes

• The Alti-IP 600 does not work with TAPI as the source phone (caller).
• When using #26 and #27 to log out/in, the Alti-IP 600 must be onhook.
Using the speaker button to use #26 or #27 will not work.
• Two dial tones are always heard when going offhook on the Alti-IP
600.
• If two calls ring into the Alti-IP 600 at the same time and the user
attempts to answer the second call, the IP phone will automatically
connect the user to the first call.
Alti-IP 600 Administration Manual 18