Altigen Alti-IP 600 Administration Manual page 23

Notes:
• IMPORTANT! Please note that the configuration in AltiWare will
override the Alti-IP 600 phone's local configuration after the IP
Phone is registered. If the IP phone's local configuration is changed
while in Basic mode, these changes will be overwritten by
AltiAdmin/ACM Admin settings. Also, after the IP Phone is
successfully registered with the system, the IP phone will overwrite
the AltiWare IP address and network-related settings on the server.
• IMPORTANT! When updating the Alti-IP 600 phone's firmware,
it is recommended that administrators perform any updates after
normal business hours or when the IP phone is not in use. If the Alti-
IP 600 phone is in use during an update, the call will be
disconnected.
• The Apply To button works with the following parameters:
General, H.323, TFTP (Server field only; Reset IP Phone and
Boot Download options cannot be applied to multiple extensions),
and Debug.
• This only works when the Alti-IP 600 is operating in basic mode.
3. Set Up Alti-IP 600 Connections
You must connect the Alti-IP 600 to the network and to a power source
before using it.
Notes:
• When the Alti-IP 600 is booted up without the PC port plugged in,
the PC port defaults to 10Mbps.
• If the PC port is to be used, the user should plug in both the LAN
port and PC port before the IP phone is booted.
• The user should reboot the Alti-IP 600 under any of the following
conditions:
— after disconnecting the LAN cable to the phone
— after changing the IP address or DHCP setting
— after rebooting the PC
Note: If the PC is rebooted during a connected call, the voice
path will be interrupted for 4-5 seconds to reinitialize the
TCP/IP protocol stack.
Alti-IP 600 Administration Manual 11