[Size]
This setting can be configured when a setting other
than [Not Used] is selected for [PinP].
Select the size of the inset in the setting screen that
appears, and press the ENTER button.
The default setting is [1/6].
3
To configure settings in other tabs, use the V , v , B ,
and b buttons to select a tab.
If you are finished configuring [Function Settings],
use the V , v , B , and b buttons to select [Apply], and
press the ENTER button to save the configurations.
3D/2D Settings
(HVO-3000MT only)
Configure the system mode for the unit and 3D settings.
1
In the [System Admin Settings] screen, use the V , v ,
B , and b buttons to select [3D/2D Settings], and press
the ENTER button.
The [3D/2D Settings] screen appears.
2
Configure each setting.
Select an item using the V and v buttons, and press the
ENTER button to display the setting screen for that
item.
[System Mode]
Select a system mode in the setting screen that appears,
and press the ENTER button.
The default setting is [3D].
3D/2D Settings (HVO-3000MT only)
87