Table of Contents
Advertisement
Configuring Recording
Settings (User Settings)
Configure input signal and image quality settings in the
[User Settings] screen.
You can navigate menus using the navigation buttons on
the front panel of the unit.
Displaying the [User Settings]
Screen
1
Press the MENU button.
The [MENU] screen appears.
2
Select [Settings], and press the ENTER button.
The [Settings] screen appears.
3
Select [User Settings], and press the ENTER button.
The [User Settings] screen appears
4
Select a tab, and configure the settings as necessary.
Configuring Input/Output Signal
Settings
Select the video and audio input/output signals.
1
Display the [I/O Switch] tab, and configure each
setting.
[Video Ch1]
Select the Ch1 input signal.
Only the signals selected in [Ch1 IN Signal Display]
in the [System Admin Settings] screen – [Function
Settings] screen – [Input Signal 2] tab will be
displayed as options for selection. However, if [HD/
SD Rec Mode] is set to [SD Record] in the [System
Admin Settings] screen – [Function Settings] screen
– [Recording] tab, 3D input signals will not be
displayed.
The default setting is the input signal displayed at the
top among those selected in [Ch1 IN Signal Display]
in the [System Admin Settings] screen – [Function
Settings] screen – [Input Signal 2] tab.
Configure the output mode in [Advanced]. For
details on this setting, see "To configure the output
mode" (page 35).
[Video Ch2]
Select the Ch2 input signal.
Ch2 only supports 2D input signals.
Only the signals selected in [Ch2 IN Signal Display]
in the [System Admin Settings] screen – [Function
Settings] screen – [Input Signal 2] tab will be
displayed as options for selection.
The default setting is the input signal displayed at the
top among those selected in [Ch2 IN Signal Display]
in the [System Admin Settings] screen – [Function
Settings] screen – [Input Signal 2] tab.
Tips
• When [Ch2 Rec] is set to [Create 2D from Ch1] in
the [User Settings] screen – [Rec/Streaming] tab,
the setting will be fixed at a 2D version of the Ch1
signal.
• When [CMS Mode] is set to [Use] in the [System
Admin Settings] screen – [Function Settings]
screen – [CMS] tab and [Ch2 Rec] is set to [Not
Used] in the [User Settings] screen – [Rec/
Streaming] tab, this setting cannot be configured.
[Audio]
Select the audio input format.
You can select from [LINE] and [MIC].
The default setting is [LINE].
[Mic Plug-In Power]
Select whether to supply power to the microphone
from the unit.
This item is available when [Audio] is set to [MIC].
The default setting is [Not Used].
You can configure the voltage that is supplied in the
[System Admin Settings].
[Output Channel]
Select the output video channel.
The default setting is [Ch1].
2
To configure image quality settings, proceed to
"Configuring Image Quality Settings" (page 35).
If you are finished configuring settings, select
[Apply] and press the ENTER button.
34
Advertisement
Table of Contents
