Installation Setup And Adjustment; Switch Settings On The Connector Panel; Setting On The Front Panel Unit - Sony DSR-80 Installation Manual

9. INSTALLATION SETUP AND ADJUSTMENT

9-1.

Switch Settings on the Connector Panel

When the unit is installed, be sure to perform the following setup and adjustment. If the adjustment is not performed, the unit may not operate
properly.
Refer to the operating instruction "Chapter 1 Editing" for setup and adjustment.
[Connector Panel]
(1) The setting of 75 Z termination switch :
REF VIDEO 75 Z ON/OFF
ON : When the line is terminated in this unit.
OFF : When another unit is connected with this unit.
REMOTE (9P) : LOCAL
RGB OUT : OFF
(2) The setting of audio input level select switch / DSR-80/80P :
+4 dBm : +4 dBu reference level on output side
0 dBm : 0 dBu reference level on output side
_6 dBm : _6 dBu reference level on output side

9-2. Setting on the Front Panel Unit

[Front Panel] (DSR-80/80P)
(1) AUDIO REC MODE SELECT
(2) VIDEO INPUT select switch setting : VIDEO IN Y-R, B/COMPOSITE/S VIDEO/ (SDI)
(3) AUDIO INPUT SELECT
(4) QSDI
[MENU Panel]
(1) SYNC PHASE
(2) SC PHASE
(3) MENU
(4)
(5) RESET (NO)
(6) SET (YES)
(7) TC PRESET / DSR-80/80P : Used for setting the TC initial value and UB data (on display block).
: Select 2CH/4CH
2CH : FS48 kHz 16 bit
4CH : FS32 kHz 12 bit
Y-R, B ; Betacam component signal
COMPOSITE ; Ordinary video signal
S VIDEO ; Y/C separation type S Video signal
: Analog/Digital (AES/EBU) / (SDI)
: Audio, Video, Time code (EXT. sel) is inputted from QSDI through the 1 BNC Cable.
: Adjusts the H sync phase of video output signal with reference to the REF. IN signal.
: Adjusts the subcarrier phase of the composite video output signal with reference to the REF. IN signal.
: Turns on and off the menu mode.
: Used for item setting in the menu, and for setting the points A and B of REPEAT.
: Used for the following purposes:
. Initialization of the menu setting
. "No" reply from the DSR-80/80P/60/60P to the inquiry.
. COUNTER reset (on display block)
: Used for the following purposes:
. Storing the menu and setting the points A and B of REPEAT
. "Yes" reply from the DSR-80/80P/60/60P to the inquiry.
13