Sony HVO-1000MD User Manual page 83

[I/O Timing]
Select the input and output timing in the setting screen
that appears, and press the ENTER button.
Select [Normal] as signal processing is usually
performed under normal circumstances. There will be
a slight delay in signal outputs when [Normal] is
selected. Select [Pass-Through] for simultaneous input
and output timing without signal processing.
The default setting is [Normal].
Note
When the HVO-3000MT is set to 3D mode, you will
only be able to select between [Normal] or [Pass-
Through] for [I/O Timing] when [Input Stream] is set
to [1] and input and output are set to the same format.
[Normal] will be used when selection is not possible.
This also applies if [Simultaneous 3D and 2D Rec] is
set to [Yes] in the [System Admin Settings] screen -
[3D/2D Settings] screen of the HVO-3000MT.
[Auto Live Still Image]
Select the type of image to display when a video is
paused in the setting screen that appears, and press the
ENTER button.
The default setting is [Frame].
[Auto Live]
Select whether to use the auto live function in the
setting screen that appears, and press the ENTER
button.
When the auto live function is enabled and you capture
a still image, the captured image is displayed for the
duration specified with the [Auto Live Time] setting.
When using the auto live function, you can also select
whether to display a single captured image or multiple
images.
In multi auto live, three or four captured images are
displayed depending on the display position setting.
[Advanced] appears when [Multi] is selected.
The default setting is [Not Used].
For details on this setting, see "To configure multi
auto live settings" (page 85).
Note
If [Auto Live] is set to [Use] while [I/O Timing] is set
to [Pass-Through], the auto live function will not
function.
[Auto Live Time]
This setting can be configured when [Auto Live] is set
to [Use].
Select the duration for which still images are displayed
after capture in the setting screen that appears, and
press the ENTER button.
The default setting is [0.5 sec].
83
Function Settings