Using A Hard Keyboard For Patient Information And Data Storage; Settings; Registering Multiple Patients In Advance - Sony HVO-1000MD User Manual

• For the HVO-3000MT, if [Simultaneous 3D and 2D
Rec] is set to [Yes] in the [System Admin Settings]
screen - [3D/2D Settings] screen, recordings will
only be saved to one external media destination.
Therefore, the [External Media 2] setting will be
ignored, even if it is configured.
[Case]
Select the corresponding procedure in the setting
screen that appears, and press the ENTER button.
Note
The procedures must be registered beforehand.
For details on this setting, see "Registering
Procedures" (page 115).
5
To perform a test recording, proceed to "Test
Recording" (page 54).
If you are finished configuring, use the V , v , B , and b
buttons to select [Done], and press the ENTER button.
Using a Hard Keyboard for Patient
Information and Data Storage

Settings

When [Keyboard Mode] is set to [Hard Keyboard] in the
[System Admin Settings] screen - [Device Settings]
screen, you can configure patient information and data
storage settings using only the connected keyboard.
When hard keyboard mode is enabled, the following keys
function as follows.
52
Recording Preparation
Key Function
Tab Move to the next input field.
Shift+Tab Move to the previous input field.
R r (arrows) Select items.
T t Move within entered text.
(arrows)
Enter Apply the setting, and close the [Recording
Preparation] screen.
Esc Cancel the setting, and close the [Recording
Preparation] screen.
Note
Hard keyboard mode cannot be enabled when the unit is in
touch panel mode.
Registering Multiple Patients in
Advance
You can register information for multiple patients of
procedures and examinations in advance. By doing so, you
can simply select the patient from the registered patient list
on the day of the procedure or examination and save time
on preparation.
Registering Patients
Register patients for procedures and examinations to the
patient list.
1
Configure patient information and save settings for the
recorded data.
For details on patient information and save settings
for recorded data, see "Patient Information and Data
Storage Settings" (page 50).
You can also configure the settings by loading data
from a card reader or barcode reader.
2
Use the V , v , B , and b buttons to select [Add to List],
and press the ENTER button.
The patient is added to the patient list.