Note
The unit can recognize the Sony UP-DR80MD printer
automatically. To have the unit recognize UP-
DR80MD printers automatically, set the peripheral
device setting for the USB connector to which the
printer will be connected to [No Device]. Be aware
that the printer will not be recognized automatically
while recording or playback is in progress or while the
[Device Settings] screen is displayed.
If you select a touch panel/mouse, be sure to configure
the [Touch Panel / Mouse Settings].
For details on this setting, see “Configuring Touch
Panel / Mouse Settings” (page 120).
[RS-232C 1], [RS-232C 2]
Select the devices connected to RS-232C connectors 1
and 2 on the rear panel of the unit in the setting screens
that appear, and press the ENTER button.
The available settings include devices that are
compatible with the unit.
The default setting is [No Device].
If you select a printer, be sure to configure the [Printer
Settings].
For details on this setting, see “To configure printer
settings” (page 92).
[Printer Used]
This setting can be configured when a printer is
selected for the [USB 3], [USB 4], [RS-232C 1], and
[RS-232C 2] settings above.
Select the printer to use in the setting screen that
appears, and press the ENTER button.
The [Advanced] settings are enabled.
Page 90