Configure The Autoprovisioning Parameters - CyberData 011113 Operation Manual

2.10.13 Configure the Autoprovisioning Parameters

Autoprovisioning can be used to configure your device automatically on boot, after a periodic delay,
after sitting idle for a period of time, or at a specified time.
The autoprovisioning file contains the board configuration in xml format. Autoprovisioned values in
this file will override values stored in on-board memory.
The autoprovisioning file can be hosted with a tftp or a web server and by default is named according
to the MAC address of the device (for example: 0020f7350058.config). The autoprovisioning
filename can also be specified.
The device does not have a real time clock but can sync with a network time server on boot.
1. Click the Autoprovisioning button to open the Autoprovisioning Configuration page. 
Operations Guide
See Figure 2-28.
Figure 2-28. Autoprovisioning Configuration Page
Installing the VoIP Indoor Intercom with Keypad
930915D
Intercom Setup
CyberData Corporation
56