CyberData 011113 Operation Manual page 32

Web Page Item
Activate Relay During Night Ring
Activate Relay While Call Active
Activate Relay on Button Press
Relay on Button Press Timeout (in seconds) Type the desired time (in seconds) that you want the relay to
Miscellaneous Settings
Auto-Answer Incoming Calls
Button and Keypad Lit when Idle
Button Brightness (0-255)
Play Ringback Tone
Note
Operations Guide
Table 2-7. Device Configuration Parameters (continued)
You can change the SIP
Microphone Gain without rebooting the device. You must save and reboot the device for
other changes to take effect.
930915D
Installing the VoIP Indoor Intercom with Keypad
Description
Check this box to activate the relay for as long as a Night Ring
tone is ringing.
When selected, the relay will be activated for as long as the call
is active.
When selected, the relay will be activated when the Call Button
is pressed.
activate after the Call Button is pressed (1 character limit).
When selected, the device will automatically answer incoming
calls.
When Auto Answer is Off, the device will play a ringtone
through the Intercom speaker until someone presses the
button.
When selected, the Call Button remains lit when idle.
Type the desired button brightness level (0-255).
When selected, you will hear a ringback tone while making a
call.
Click on the Test Audio button to do an audio test. When the
Test Audio button is pressed, you will hear a voice message
for testing the device audio quality and volume.
Click on the Test Microphone button to do a microphone test.
When the Test Microphone button is pressed, the following
occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click on the Start Button Test button to do a button test. When
pressed, the button text will change to Stop Button Test and in
this mode, pressing the button will play test audio. Also,
pressing this button puts the device into a mode where it will
play audio as the buttons are pressed. For buttons 0 through 9
it will play the audio file for that number. For buttons *, #, and
the Call Button, it will play the appropriate DTMF tones.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Volume, Multicast Volume,
Intercom Setup
Ring Volume, Sensor Volume, and
CyberData Corporation
25