Configure The Intercom Parameters; Factory Default Settings - CyberData 011113 Operation Manual

2.10 Configure the Intercom Parameters

To configure the Intercom online, use a standard web browser.
Configure each Intercom and verify its operation before you mount it. When you are ready to mount
an Intercom, refer to

2.10.1 Factory Default Settings

All Intercoms are initially configured with the following default IP settings:
When configuring more than one Intercom, attach the Intercoms to the network and configure one at
a time to avoid IP address conflicts.
Parameter
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
a. Default if there is not a DHCP server present.
Operations Guide
Appendix A, "Mounting the VoIP Indoor Intercom with Keypad"
Table 2-4. Factory Default Settings
a
a
a
930915D
Installing the VoIP Indoor Intercom with Keypad
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
CyberData Corporation
18
Intercom Setup
for instructions.