CyberData 011113 Operation Manual page 38

2.10.6.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP Configuration page
Operations Guide
parameter is not selected.
Figure 2-17. SIP Configuration Page Set to Point-to-Point Mode
Intercom is set to NOT register with a SiP server
Installing the VoIP Indoor Intercom with Keypad
(Figure 2-17), make sure that the Register with a SIP Server
930915D
Intercom Setup
CyberData Corporation
31