Settings / Modifications / On-Site Adaptation; Using The Keyboard For Programming; Code Entry - Meiko EcoStar 545D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
Datei:1_EcoStar545D-M_9662798_Betriebsanleitung_EN_2009-05.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
16

Settings / modifications / on-site adaptation

16.1 Using the keyboard for programming

Increase value/
Decrease value/
move forward
move backwards
Function field
Access codes for various user-levels have been defined. Once the complete code has
been entered, the entered code is compared with the internal code table. Depending on
the code entered, the corresponding user level will be accessed. 2 access codes are
available for each user level; the first is for restricted access, i.e. no modification of pa-
rameters is possible (viewing mode), and the second gives access to the entire range of
functions (viewing and modification).
In the short programming instructions accompanying every machine in the series, this is
described in condensed form.
For control programming, the power supply must be available but the machine must be
completely switched off (no LED must be illuminated).
Code – input:
View service data:
Modify service data:
View configuration data:
View dosing technology:
Modify dosing technology:
The code numbers for the further levels can be found in the Service Manual.

16.2 Code entry

To get into the code entry mode, you should keep the key "0" pressed (for around 3 sec-
onds) until you see
By pressing the key "0" once again you can leave the programming area at any time.
The digit to be modified will flash.
Press the "I" key to increase the value/code indicated on the display unit, or press the "II"
key to decrease it, or press the "accept" key to save it. The next value will then flash and
will be the only one visible.
Update:2009-12-18 MRL
W e reserve the right to change execution and construction!
Accept /
modify
Value field
CODE 10000
CODE 10001
CODE 20000
CODE 40000
CODE 40044
on the display unit..
Exit / Start Pro-
gramming
24/42
9662798