Settings / Modifications / On-Site Adaptation; Using The Keyboard For Programming; Code Entry - Meiko EcoStar 430 F-MIKE Operating Instructions Manual

Operating instructions EcoStar 430 F-M
Datei:1_EcoStar430F-MIKE_9702129_Betriebsanleitung_EN_2012-07.docx
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
16

Settings / modifications / on-site adaptation

16.1 Using the keyboard for programming

Increase value/
Decrease value /
move forward
move backwards
Function field
Access codes for various user-levels have been defined. Once the complete code has
been entered, the entered code is compared with the internal code table. Depending on
the code entered, the corresponding user level will be accessed.
2 access codes are available for each user level; the first is for restricted access, i.e. no
modification of parameters is possible (viewing mode), and the second gives access to
the entire range of functions (viewing and modification).
In the short programming instructions accompanying every machine in the series, this is
described in condensed form.
For control programming, the power supply must be available but the machine must be
completely switched off (no LED must be illuminated).

Code entry:

View service data:
Modify service data:
View configuration data:
The code numbers for the further levels can be found in the Service Manual.
16.2 Code entry
To get into the code entry mode, you should keep the key "0" pressed (for around 3 se-
conds) until you see
By pressing the key "0" once again you can leave the programming area at any time.
The digit to be modified will flash.
Press the "I" key to increase the value/code indicated on the display unit, or press the "II"
key to decrease it, or press the "accept" key to save it. The next value will then flash and
will be the only one visible.
If your entry is incorrect you will exit the code entry procedure, and the information code
122 will be displayed.
Update:
W e reserv e the right to change execution and construction!
accept/ modify
Value field
user-levels have
CODE 10000
CODE 10001
CODE 20000
on the display unit..
y Exit / Start Pro-
gramming
9702129 22/38