Meiko EcoStar 545D-M Operating Instructions Manual page 27

Operating instructions EcoStar 545 D-M
Datei:1_EcoStar545D-M_9662798_Betriebsanleitung_EN_2009-05.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
The function "vent detergent pipe" is not existing with machines including detergent
dosing system type ADT ('Advanced Dosing Technology with depression dosing). The
detergent dosing pipe is vented automatically when the first cycle is running, after filling
of the detergent reserve container.
16.3.4 Resetting the TE degree of depletion display
this display by pressing the "accept" key.
If the option "Display degree of depletion" is active during operation with partial deminer-
alization cartridges, the counter has to be reset using the function above after the car-
tridge has been changed
You can leave this level by pressing the "0" key again.
16.3.5 First-time-filling of boiler
this display by pressing the "accept" key.
After emptying the boiler (repair of descaling) it must be filled with water again before the
heater is switched on. This is achieved using this parameterization.
You can leave this level by pressing the "0" key again.
16.3.6 Configuration level
You can find the list of configuration parameters on this level (parameter numbers 2xx). +
Here you can view these and modify them. You can also call up the status of the inputs
and outputs, or set the outputs for testing.
On the service level, you will first see the display below:
This corresponds to the viewing/modifying parameters. (see 15.3.7)
This corresponds to viewing the status of inputs. (see 15.3.8)
This corresponds to viewing and setting the status of outputs. (see 15.3.9)
Press the "I" key to move forwards or the "II" key to move backwards or the "accept" key
to make a selection. You are now at the current level.
Update:2009-12-18 MRL
W e reserve the right to change execution and construction!
27/42
9662798