Regeneration; Basic Information On The Appliance; General Description Of The Washing Machine - Meiko EcoStar 545D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M

11.4 Regeneration

ATTENTION!
ATTENTION!
ATTENTION!
Datei:1_EcoStar545D-M_9662798_Betriebsanleitung_EN_2009-05.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Press the OFF-key.
Remove the stand-pipe, empty the tank.
Fill the salt solution container with 0.8 kg regenerating salt. A funnel can be used for
this if necessary.
By regenerating salt we mean here sodium chloride with a grain size of 0.3 to 1 mm.
The seal and the thread of the salt solution container must be cleaned before closing
the container. Carefully lock the salt solution container cover. The penetration of wash
water can reduce the capacity of the built-in water softening device.
•
Press the regeneration button.
•
The regeneration process starts automatically and lasts for about 25 minutes.
The machine cannot be used during this time. The hood must remain closed.
The regeneration process is indicated by a yellow light. The machine can be filled again
when the light has gone out.
•
Even if the red light has not come on to indicate that the water softener is ex-
hausted, the regeneration process can be started by pressing the regeneration but-
ton for at least 3 seconds.
We recommend that you fill the machine immediately after the regeneration process in
order to dissolve and remove from the wash tank any salt particles that have been
spilled.
If the salt remains in the wash tank for a lengt hyperiod, this can result in corrosion and
even pitting corrosion in the bottom of the tank.
12

Basic information on the appliance

Each dishwashing machine is manufactured acc. to the latest state of the art technol-
ogy. Operation is safe.
Dangers could arise from this model, if it is not correctly operated by unsuitable operat-
ing staff or if it is not used acc. to it's purpose.
Liability
We accept no responsibility for damage of the appliance and other objects caused by op-
erating faults, resp. non-observance of the operating instructions. Any modifications to
the appliance - especially technical modifications inside - undertaken by unauthorised
persons without the written permission of the manufacturer will invalidate the warranty.

12.1 General description of the washing machine

12.1.1 Execution
Square basket appliance with stationary basket
12.1.2 Wash principle
The appliance has one wash and one final rinse cycle.
The temperature regulator keeps the wash temperature. A centrifugal pump circulates the
water out of the cleaning tank into the clean nozzles. The water jets reach the items to be
cleaned out of differing directions. Therefore an even washing result can be guaranteed.
Update:2009-12-18 MRL
W e reserve the right to change execution and construction!
19/42
9662798