Christie 1000W J Series Setup Manual page 38

Section 4: Maintenance
3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens
assembly in place. See
4. Remove the front lens cap.
5. For added stability such as motion applications, fasten the security screws provided with the lens mount.
See Figure
6. Use a 5mm hex driver to fasten the red security screws provided with the lens mount
1) Recommended for heaviest lenses such as 0.73:1 and 1.2:1. 2) The red security screws MUST be
installed when hoisting the projector overhead, or installing the projector in an overhead position.
WARNING
4-6
Figure 4-8 .
4-9.
Use of the lens red security screws or the lens retaining screws is required if the
projector is hoisted or installed in an overhead position.
F 4-8
IGURE
F 4-9
IGURE
4-9). NOTES:
(Figure
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)