Table of Contents
Advertisement
When finished with a function menu:
• Press E
XIT
to return to the previous screen.
OR
• Press M
ENU
to leave the menu system and return to the presentation.
NOTES: 1)
If there is no signal present, all source-dependent adjustments are disabled.
inactivity, the projector leaves the menu system and returns to the presentation.
only.
On-line Help
Press H
to display summary information about the current menu or highlighted option. Press H
ELP
exit.
1.
Size & Position
2.
Image Settings
3.
Channel Setup
4.
Configuration
5.
Lamp
6.
Status
7.
Input Switching & PIP
8.
Test Pattern
9.
Language
The Global Icon
Menu options that include this icon apply universally. Menu options without this icon apply to the
selected channel only, or are unsaved diagnostic settings.
Using Slide bars and Other Controls
Most of the function menus allow you to change settings by using slide bars, check boxes, and pull-down lists.
Navigating options:
• Enter the menu option number corresponding to the setting you wish to change (for example, press M
3 to select "Vertical Stretch" in the Size and Position menu).
• Move the highlight to the option desired and press E
• Move the highlight to the option desired and press L
• You can bypass the menus entirely and use a single key to immediately access an adjustment during your
presentation (applies only to options having their own key, such as Contrast, Brightness, Gamma, etc.).
• For "blind" access, hide the entire menu system (see OSD key, above) and access using the proper sequence
of key presses.
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
Main Menu
Help
Off
English
Help
Use this menu to adjust settings affecting current image
size and position, such as horizontal and vertical
placement, blanking, resizing, and others.
NTER
.
/R
A
K
EFT
IGHT
RROW
EY
Section 3: Operation
2)
After 15 minutes of
3)
The Status menu is read-
ELP
to adjust immediately.
again to
1
ENU
3-9
Advertisement
Table of Contents
