Table of Contents
Advertisement
Channel
Select a specific source setup (channel) defined and stored in projector memory. Once you enter a two-digit
channel number (or, if there is a list displayed, highlight it and press E
change and update according to the numerous setup parameters defined for that channel.
is automatically created if you adjust an image from a new source.
C
HANNEL
NOTE:
option is enabled in the Menu Preferences menu. You can choose to use a scrollable list of channels when
you press C
HANNEL
feedback. See Menu Preferences later in this section.
Slot 1, 2, 3, 4
Press to display the next active input on the card in the slot.
Input
Displays all inputs in all slots, both active and inactive. Scroll through the list to select an input for the main
image. Press Input again to show the list and select the picture-in-picture (PIP) image.
PIP
Turns PIP ON or OFF.
Swap
Swaps the main and PIP images.
Contrast
Changes the level of peak white in your images. Use L
of contrast—for best results, start low and increase so that whites remain bright but are not distorted or tinted
and that light areas do not become fully white (i.e., "crushed"). Conversely, low contrast causes dim images.
Bright
Increases or decreases the black level in the image. Use L
level of brightness. For best results, start high and decrease so that dark areas do not become fully black (i.e.,
"crushed"). Conversely, overly high brightness changes black to dark grey, causing washed-out images.
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
key behavior during a presentation depends on whether or not the Display Channel List
, or you may prefer to enter the desired channel number "blind", i.e., without on-screen
NTER
), the display will automatically
/R
A
K
EFT
IGHT
RROW
EY
/R
A
K
EFT
IGHT
RROW
Section 3: Operation
NOTE:
A new channel
until you reach the desired level
EY
until you reach the desired
3-5
Advertisement
Table of Contents
