Christie 1000W J Series Setup Manual page 12

Section 2: Installation and Setup
2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating
connector on the lens mount. Fully insert the assembly straight into the lens mount opening without
turning. Press using your hand as shown in
lens is not inserted at an angle, as this can cause damage.
3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens
assembly in place. See
4. Remove the front lens cap.
5. For added stability such as motion applications, fasten the security screws provided with the lens-mount.
See Figure
2-2
Figure 2-3 .
2-4.
NOTE:
Figure 2-2. When installing the lens, ensure that the
F 2-2
IGURE
F 2-3
IGURE
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)