Alarms - Christie 1000W J Series Setup Manual

Section 3: Operation
Edit numerical values:
Enter numbers directly from the keypad to specify numbers representing projectors channels (source setups),
or slots. As each digit is entered, it is inserted on the right of the field, and the numbers already in the field are
shifted on the left. The channel numbers are defined with two digits—for example, if you enter only a single
digit (such as "7") for a channel number, the channel will automatically be defined as "07".
Enter "07" to utilize this channel. If you press any non-numbered key, the number entered up to that point is
accepted and updated as the new value. Press E
3.3

Alarms

There are two types of alarms:
• Warning Alarm
• Critical Alarm
A warning alarm is generated when an error or a non-optimal condition occurs that will not prevent the
projector from operating. An example is when a temperature is slightly elevated.
A critical alarm is generated when a condition occurs that could prevent the projector from operating and could
cause damage to the projector. This may cause the projector to shut down automatically. An example would be
a fan not running.
Alarms are displayed:
• on the projector LCD
• in the Status Menu of the OSD (if active)
• in the Web User Interface
NOTES: 1)
When an alarm is displayed on the LCD, the built-in keypad is disabled. Press the OK soft key to
re-enable the built-in keypad.
When the status of the alarm item is within normal range, the alarm will clear.
3-12
XIT
to cancel editing of numerical values.
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)