N005：Setting Frequency; N006：Communication Station No; N007：Timer Runtimes; N008：Alarm Type - Panasonic VF100 Instruction Manual

n005£ºSetting frequency
Indicates the setting frequency of the inverter.
n006£ºCommunication station No.
Indicates the set communication station No..
Communication station No. can be set with P136: communication station No. setting.
n007£ºTimer runtimes
In timer's multi speed operation, timer's acceleration and deceleration linking operation,
pulse input multi speed operation and pulse input acceleration and deceleration linking
operation, runtimes in a cycle during each operation are displayed. When a cycle starts,
runtimes will be counted up. When each operation ends, input the next run command,
the counted numbers will be cleared.
Timer runtimes can be set with P068: timer runtimes.
n008£ºAlarm type
Indicates the lighting details of the alarm LED.
* Alarm LED operation select (parameter P147) set to "1"
When various alarms occur simultaneously, the displayed order of priority is shown
as follow. (If alarm in higher priority order is in operation, even an alarm in lower priority
order enters, the alarm in higher priority order is still displayed.)
Temperature
anomaly
alarm
Alarm state
Without error
Output voltage trouble
alarm
Overload alarm
Temperature anomaly
alarm
Timer end-of-run signal
Overload Output voltage
•„ •„
alarm trouble alarm
Display
Timer
•„
end-of-run signal
47