Upload Function Of Parameters (Cpy1) - Panasonic VF100 Instruction Manual

Note
•E Function parameter data of the main unit connected with the operation panel will not change
even if built-in memory parameter data is changed.
•E While changing the data, the mode will return to the "operation status display mode" if a stop
signal is input and the inverter stops.
•E During data changing, the "0V stop state" will be returned to if the inverter stops at zero.
•E While changing the data in the "0V stop", the mode will return to the "operation status
display mode" if the inverter enters operation state.
•E During operation, the parameters other than those that can be changed will be monitored only.
(The data can only be displayed, but cannot be changed.)
•E While setting and changing the data, the set data will be written in non-volatile memory inside
the inverter and the data will be stored even if the power is turned off. Max. writing times of the
non-volatile memory inside the inverter is 100,000 times. Note that function parameter No.
cannot be changed too frequently.

11-2 Upload function of parameters (CPY1)

Upload all function parameters of the main unit connected with the operation panel to built-in memory
inside the operation panel. After data value is set to "UPL", all upload will start.
¡ö Upload method of function parameters
STOP
Press the STOP button to stop the inverter.
Press the MODE button.
MODE
MODE
Press the MODE button.
Press the MODE button.
MODE
Press the MODE button.
(If a password is set, it's necessary to input the
MODE
password. Refer to page 139.)
[Continued to next page]
147