Initial Settings For Custom Parameter No.1-10 - Panasonic VF100 Instruction Manual

Initial settings for custom parameter No.1~10 are shown in the table as below.
Custom
parameter No.
U001
U002
U003
U004
U005
U006
U007
U008
U009
U010
For making the distribution setting of custom parameter No.1~10 return to initial state, value of
function parameter "P151: Setting data clear" is set to "3". (The data value is not changed.)
(Refer to page 140.)
Note
•E After the distribution is completed, the inverter will not run unless the MODE button is pressed
and the "operation status display mode" is set to.
•E While changing the data, the mode will return to the "operation status display mode" if a stop
signal is input and the inverter stops.
•E During data changing, the "0V stop state" will be returned to if the inverter 0V stops.
•E While changing the data in the "0V stop state", the mode will return to the "operation status
display mode" if the inverter enters operation state.
•E The distribution of custom parameters is stored in the panel, so such distribution is still valid even
if the panel is removed from this inverter and then installed on other inverters.
142
Function
Function name
parameter No.
st
P001 1 acceleration time
P002 1 st deceleration time
P007
Torque boost level
P003
Operation command select
P004 Frequency setting signal
P008 Max. output frequency
P009 Base frequency
P145 Operation status monitor
P147 Alarm LED operation select
P150 Password
Initial Related
value page
5.0 62
5.0 62
05 68
63
0
64
0
69
50.0
69
50.0
136
0
0 138
139
0000