P090: Output Tr1 Function Select; P091: Output Tr2 Function Select - Panasonic VF100 Instruction Manual

P090£ºOutput TR1 function select
P091£ºOutput TR2 function select
Used to set functions of open-collector output 1 (control terminals No.10-12) and open-collector
output 2 (control terminals No.11-12).
TR1 TR2
P090 P091
0 0
Run signal
Reverse
1 1
run signal
2 2
Arrival signal
Overload
3 3
alarm
Frequency
4 4
detect
Current
5 5
detect (1)
Current
6 6
detect (2)
7 7 Fault alarm (1)
8 8 Fault alarm (2)
End of timer's
9 9 one cycle
operation
End of timer's
10 10
operation
Output state
11 -
signal
Note
•ERetardation time of current detect signal set to "5" and "6" can be set with "P096: Retardation
time of current detect".
•ESetting data "10" is used to output the time set with "P070: Continuous wait time of timer's
operation".
•EOutput frequency ratio or output current ratio of setting data "11" is set with parameter P097.
•ESetting data "11" can only be used to set open-collector output 1 (TR1).
Conditions for open-collector output to turn ON
Function
ON when run signal is ON or during inverter output
ON when the inverter is running in reverse
ON when the output frequency is within the setting
frequency¡À2Hz
ON when the output current is 140% of the rated current or
higher or when the electronic thermal level is reached.
ON when output frequency is higher than detect frequency
(parameter P093 setting )
ON when output current is higher than
detect current level (parameter P095 setting)
ON when output current is lower than detect current level
(parameter P095 setting )
ON when the inverter is in the fault trip state
ON when the inverter is in the normal state
(OFF when the inverter is in the fault trip state)
ON when timer operates one cycle (only output during wait time)
ON when timer's operation ends (when "tEnd" is displayed)
Usually output PWM signal that is in direct proportion to
output frequency or output current
P070, P093
Related
¡«
P095 P097
parameters
105