P097: Analog And Pwm Output Function Select - Panasonic VF100 Instruction Manual

P097£ºAnalog and PWM output function select
Used to set function of "0~10V voltage signal" output with control circuit terminal No.17 and "output
state signal (PWM)" output with terminals No.10-12.
Data setting
value
0 Output signals in proportion to output frequency
1 Output signals in proportion to output current
[Relationship between 0~10V voltage signal and output frequency and output current]
£¼In proportion to output frequency £¾
•iV•j
Voltage
10
signal
output
0
Output frequency
[Relationship between output signal and output frequency and output current]
£¼In proportion to output frequency£¾
•i%•j
75
Duty
factor
0
Output frequency
•E Cycle of PWM output signal is "1ms".
[Precautions on 0~10V voltage output and output state signal (PWM)]
•E
The indications of the output signal are not the accurate indications for measuring. Use those
indications to get rough values.
(If you need the accurate values, use a separate measuring instrument.)
•E Note that the signal in proportion to output current may output large signal value under 40%
of rated current.
(For example, signal level will be output to a certain extent even if no output current is available.
But if the inverter is in the stopping state, "0 level" is output.
Note
•E For the purpose of acquiring "PWM output" with terminals No.10-12, parameter P090 (output
TR1 function select) is required to be set to "11".
Details
£¼n proportion to output current£¾
•iV•j
Voltage
10
signal
output
Max. output
frequency
0
£¼In proportion to output current£¾
•i%•j
75
Duty
factor
Max. output
frequency
0
150% of rated
output current
Output current
150% of rated
output current
Output current
Related
parameters
P090, P098
109