Panasonic VF100 Instruction Manual page 145

[Continued from previous page]
Press the SET button to set the data.
SET
If data is changed during operation, new data is
applied hence.
Note
•E After the data is set, the inverter will not run unless the MODE button is pressed and the "operation
status display mode" is set to.
•E While changing the data, the mode will return to the "operation status display mode" if a stop signal
is input and the inverter stops.
•E During data changing, the "0V stop" will be returned to if the inverter 0V stops.
•E While changing the data in the "0V stop state", the mode will return to the "operation status
display mode" if the inverter enters operation state.
•E During operation, the parameters other than those that can be changed will be monitored only.
(The data can only be displayed, but cannot be changed.)
144