Parameter Setting - Panasonic M2X Series Instruction Manual

Parameter Setting

Setting
Operation Panel
2-digit LED
* Normally in the monitor mode, the operation panel displays frequency (Hz).
* The indicated value is just for reference. Do not use this device as a measuring instrument.
Also, the operation panel can display the magnification factor specified by [
factor].
Displays an output frequency, set frequency, value magnified by the scale factor,
5-digit LED
cause of error and parameter value.
Display a parameter number. In the monitor mode, the direction of motor rotation
2-digit LED
is displayed.
Used to change the monitor mode. Pressing this switch changes the monitor as
follows:
MODE switch
Used to switch between the parameter No. mode and the parameter value mode,
DATA SET switch
and to register a parameter value.
●
Description on each mode
Monitor mode
Parameter No.
Use to select, set and modify a parameter.
△ ▽ switch
Can be held down for continuous changing.
RUN switch
Issues the run command.
STOP switch
Issues the stop command.
Panasonic Panasonic Panasonic Panasonic
ＳＴＯＰ ＲＵＮ
ＤＡＴＡ
ＭＯＤＥ
ＳＥＴ
Output frequency
Displays an output frequency, converter voltage and motor current.
At power-ON, the operation panel is set to this mode.
If the MODE
parameter value mode, the display will be changed to this mode.
A parameter number (
is pressed in the monitor mode, the display will be changed to this
mode
mode.
A parameter set value blinks. The set value can be changed with
Parameter
the or
△
value mode
Pressing the
registers the updated value.
pressed, the data will not be registered.
*
r/min
Hz
Ａ
Ｖ 5-digit LED
^
Converter voltage
switch is pressed in the parameter No. mode or
)) blinks. If the
-
button.
▽
DATA SET switch after changing a set value
Even if the
- 21 -
Display scale
Motor current
DATA SET switch
MODE switch is