IBM System x3200 Problem Determination And Service Manual page 76

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, System x3200 Types 4362 and 4363," on page 67 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
System-error log message
System is over recommended voltage for +3.3V
System is over recommended voltage for 1.5V
CPU
System is over recommended voltage on VRM 1 (Trained service technician only) Reseat the microprocessor.
System is under recommended voltage for
+3.3V
System is under recommended voltage for 1.5V
CPU
System is under recommended voltage on VRM
1
System log 75% full
System log cleared
System Memory Error
System over recommended voltage for +12V
System over recommended voltage on +2.5V
System over recommended voltage on
continuous +5V
58
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
Action
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
(Trained service technician only) Reseat the microprocessor.
Clear the current logs.
Information only.
1. Reseat the DIMMs.
2. Replace the DIMMs.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2. (Trained service technician only) Replace the system board.