Removing The Front System Fan Assembly - IBM System x3200 Problem Determination And Service Manual

Removing the front system fan assembly

This procedure applies only to server models that have a front system fan
assembly.
Attention:
v Replace a failed fan within 48 hours.
v To ensure proper cooling and airflow, do not operate the server for more than 30
To remove the front system fan assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 77).
4. Disconnect the fan assembly cable from the system board, making a note of
5. Press and hold the drive cage release tab; then, rotate the drive cage out of the
6. Pull out on the front system fan assembly release tabs; then, rotate the fan
7. Remove the power cables from the slot on the fan assembly; then, rotate the
8. If you are instructed to return the fan assembly, follow all packaging instructions,
minutes with the side cover removed.
on page 73.
and external cables.
where the cable was connected for later installation.
chassis until the retaining tab on top of the cage locks into place.
assembly away from the drive cage slightly.
fan assembly away from the drive cage and remove the fan assembly from the
drive cage.
and use any packaging materials for shipping that are supplied to you.
Release tabs
Slot
Front fan assembly
Chapter 4. Removing and replacing server components
107