IBM System x3200 Problem Determination And Service Manual page 107

Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the
beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
2. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
3. Follow the instructions that come with the drive to set jumpers or switches, if
there are any.
Note: You might find it easier to install the new drive from the front and then
attach the cables.
4. If you are installing a 3.5 in. drive in bay 2, attach a 5.25 in. conversion kit to
the 3.5 in. drive.
5. Remove the drive retainer clip from the side of the drive cage of bay (see the
illustration at the beginning of this section). Slide the drive retainer clip to the
left to remove it from the drive cage; then, snap the drive retainer clip into the
screw holes on the side of the drive (the blue side of the drive retainer clip
should be facing outward).
6. Push the drive into the bay.
Chapter 4. Removing and replacing server components
89