IBM System x3200 Problem Determination And Service Manual page 149

Select this choice to view the processor information, including the type, speed,
and cache size of the microprocessor.
v System Information
Select this choice to view information about the server. When you make changes
through other choices in the Configuration/Setup Utility program, some of those
changes are reflected in the system information; you cannot change settings
directly in the system information.
This choice is on the full Configuration/Setup Utility menu only.
v Devices and I/O Ports
Select this choice to view or change device assignments and input/output (I/O)
ports. Select this choice to enable or disable the mini-PCI Express SAS and
Ethernet controllers, and standard connectors (such as serial and parallel).
Enable is the default setting for all controllers. If you disable a device, it cannot
be configured, and the operating system will not be able to detect it (this is
equivalent to disconnecting the device). If you disable the mini-PCI Express
SAS/SATA controller and no SAS adapter is installed, the server will have no
SAS capability. If you disable the integrated Ethernet controller and no Ethernet
adapter is installed, the server will have no Ethernet capability.
This choice is on the full Configuration/Setup Utility menu only.
– Serial Port 1
Select this choice to set up the serial port 1.
– Serial Port 2
Select this choice to set up the serial port 2.
– Parallel Port Setup
Select this choice to setup the parallel port.
– Remote Console Redirection
Select this choice to enable and configure serial remote video and keyboard
redirection.
– Internal Floppy Disk
Select this choice to disable or enable the internal diskette drive.
– Mouse
Select this choice to specify whether the mouse is installed or not installed.
– Planar Ethernet
Select this choice to disable or enable the Ethernet on the system board.
– System MAC Address
Select this choice to view the MAC addresses for network devices that are
installed in the server.
– Parallel ATA
Select this choice to disable or enable the Parallel ATA.
– Serial ATA
Select this choice to disable or enable the Serial ATA.
– Native Mode Operation
Select this choice to configure the Native Mode Operation.
– SATA Controller Mode Option
Select this choice to configure the SATA Controller Mode Option.
– SATA AHCI
Select this choice to configure the SATA AHCI. This selection is hidden if the
SATA Controller Mode Option is set to compatible.
Chapter 5. Configuration information and instructions
131