Using The Serverguide Setup And Installation Cd - IBM System x3200 Problem Determination And Service Manual

v Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
Using passwords
You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for the
power-on (user) password or the administrator password.
If you set a power-on password and an administrator password, you can type either
password at the password prompt that appears as you start the computer. However,
if you want to change the settings in the Configuration/Setup Utility program, you
must type the administrator password to access the full Configuration/Setup Utility
menu. If you type the power-on password, you have access to only the limited
Configuration/Setup Utility menu.
Keep a record of the password in a secure place. If you forget the power-on or
administrator password, you can regain access to the computer through one of the
following methods:
v If you have forgotten the power-on password and an administrator password is
v Remove the battery and then install the battery.

Using the ServerGuide Setup and Installation CD

The ServerGuide Setup and Installation CD contains a setup and installation
program that is designed for your server. The ServerGuide program detects the
server model and optional hardware devices that are installed and uses that
- LAN settings
Select this choice to view the Mini-BMC, IP, subnet, and gateway
addresses.
– NMI Option
Select this choice to enable or disable the NMI reboot. Enabled is the default
setting.
Select this choice to view or clear error logs.
– Post Error Log
Select this choice to view the Post Error log entries.
– System Event/Error Log
Select this choice to view the system event and error messages that the
system generated during POST and runtime. Press Enter to erase the system
event/error log.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.
set, type the administrator password at the power-on prompt. Start the
Configuration/Setup Utility program and change the power-on password.
Chapter 5. Configuration information and instructions
133