Fantic Caballero 125 series Owner's Manual page 63

You can reset the counter for this parameter by
pressing the button for about 2 seconds at the
MAX function, until the value 00 appears. MAX
can be reset either while the vehicle is moving
or while it is standing still. If you change the unit
of measure, the value is converted in to the se-
lected unit. The data is not permanently memo-
rized.
If there is no power supply, the value for MAX is
permanently lost.
CLOCK FUNCTION (TIME)
This function describes the correct operation/
display of the current time function. This func-
tion is always represented in the format hh:mm,
using digits 6÷9 (fig. G). The clock remains active
even when the micro-controller goes into sleep
mode. The time can be set only when the vehicle
is stopped, by entering the setup menu.
km/h
TOTAL
H
L
Clock (fig. G)
The information is not saved in memory. Se-
quence displayed:
from 0:00 to 23:59 for the mode 0-24
from 0:00 to 12:59 for the mode 0-12 a.m.
from 1:00 to 11:59 for the mode 0-12 p.m.
Clock precision: ± 2.5 seconds/day.
If there is no power supply, the value for
TIME is permanently lost.
BATTERY CHARGE LEVEL FUNCTION (ONLY
125CC VEHICLES)
The information is shown by means of the
graphic bar in the lower left part accompanied
by the battery symbol, as shown in figure H. The
graphic bar, updated every 0.5 seconds, is man-
aged according to the following table (tolerance
± 0.1V).
km/h
TOTAL
H
L
Battery charge alarm (fig. H)
BATTERY VOLTAGE ALARM (ONLY125CC VEHI-
CLES)
Any time the measured voltage drops below 9.5V
(± 0.1V), the system activates the alarm routine
to signal that the dashboard may lose its settings
after the vehicle is started.
The signal consists of showing the graphic bar
of the battery voltage, regardless of the current
function. The battery symbol flashes and the bor-
der of the graphic bar appears as in figure L.
The alarm condition ceases when voltage is once
again above 10.5V (± 0.1V).
km/h
TOTAL
H
L
Battery charge level (fig. L) Battery charge level (fig. L)
SETUP MENU
The setup menu can be accessed only when the
vehicle is standing still. To do so, press the but-
ton for the TOTAL function for about 5 seconds.
Access is not possible if the dashboard is pow-
ered only by the backup battery to limit power
consumption.
The display will show a screen with the message
"SETUP" (fig. M) for access to the menu for set-
ting parameters. Release the button to access
the controls.
Setup menu access (fig. M)
SETTING THE PARAMETERS
When you release the button after fig. 8-1, the
screens shown in fig. N are shown in sequence.
63