Bearing Replacement - Suzuki RM-Z250 Owner's Service Manual

BEARING REPLACEMENT

• Remove the spacers.
• Remove the needle roller bearings 1. (26 pieces of needle
roller bearing)
• Remove the dust seals 2.
• Remove the needle roller bearing cage 3 with the special
tool.
" 09921-20240: Bearing remover set (Remover 17 mm)
• Press the new needle roller bearing cage with the special tool
and a suitable size socket wrench.
NOTE:
When installing the needle roller bearing cage, the stamped
mark on the bearing must face left side.
Position the needle roller bearing cage by referring to the illus-
tration of page 18-22.
" 09924-84521: Bearing installer
• Press the new dust seals with the special tool and a suitable
size socket wrench.
NOTE:
When installing the dust seal, the stamped mark A on the dust
seal must face inside.
" 09924-84521: Bearing installer
• Apply grease to the needle roller bearings and install them.
• Apply grease to the dust seals and spacers.
• Install the spacers B and C.
B For right side
C For left side
% 99000-25010: SUZUKI SUPER GREASE "A"
(or equivalent grease)
REAR SUSPENSION 18-6